Good installation practice
On installation customers must consider the required creepage and clearance distances between the PSU and the end-equipment enclosure. These distances vary depending on the installation class and safety standard requirements.
For Class I installations there should be 3-4mm between any part of the PSU and any earthed metal part of the enclosure. 3mm is acceptable for IT applications, 4mm required for medical applications. In Class I installations the PSU earth point must be connected to system safety ground.
For Class II installations distances may need to be increased if being installed into a surrounding metal enclosure.
Ensure consideration of components on the underside of the PCB or low lying spills when measuring clearance distances between the PSU and the end-equipment. Also top surface especially in tight enclosures such as 1U boxes. An insulation material can be used between PSU and metal if smaller gap required.
FiDUS recommends installing the PSU on 6mm stand offs typically, but check the distances.
Conducted and radiated emissions compliance is a common application consideration. It is important to remember that even when using a properly filtered PSU, an application may still not achieve compliance if it is not designed to minimise emissions. That being said, there are a number of things that can be done to optimise EMC performance either as best practice, or if you are struggling for compliance:
- Connect all marked EMI ground points to earth. Often these are combined with the safety earth point (in class I installations), but on some power supplies there may be additional earth tags or mounting points.
- Minimise the length of input/output wiring where possible and try to maintain max distance of the conductors from the PSU, to prevent noise pick up.
Avoid bundling input and output cables together. A common component to avoid placing wiring near is the PFC inductor in power factor corrected
- Apply additional filtering before the PSU input (ensure consideration of which frequencies there are issues with before selecting a filter).
- When using an open frame PSU, mount the supply on a metal plate and connect EMI mounting points.
- In multi circuit systems, decouple the circuits locally.
- Ferrites added between the PSU and system input connector and/or the DC output cables can help in reducing radiated noise issues in systems. If seen,
issues are commonly in the 30-150MHz area.
For more detailed assistance, if you still have any concerns with compliance, please get in contact with our Engineering department who are on hand to assist with any queries.
Thermal management is an important consideration when thinking about equipment service life. Electrolytic capacitors within the PSU wear with time and are typically the first end-of-life failure. Keeping the operation temperature of key components within the PSU, such as the electrolytic capacitors, as low as possible is paramount.
As a general rule, for every 10°C drop in the operating temperature of the electrolytic capacitators you double their lifetime, and thus the lifetime of the power supply. When looking at thermal performance it is helpful to test under a worst-case set of conditions, to ensure component temperatures are in an acceptable range for the required service life. Then consider the impact of operational time, load and temperature profile to estimate a more realistic lifetime for your PSU.
Also, many FiDUS power supplies offer a Peak Power rating to provide for customers with pulsing loads. When using a peak power capability customers must consider:
- Peak duration rating: the maximum length of time the peak can be drawn for
- Duty cycle: the frequency with which the peak can be drawn. (e.g. 10% duty cycle, 1 second on:9 seconds off)
- Average power value: datasheets will state the maximum average power acceptable with peak power PSUs.
- If any of these elements are exceeded the supply may overheat, with performance and lifetime suffering as a result.
The new RHM250 series from FiDUS Power is rated at 250W natural convection and provides 7 different output voltages from 12 to 48VDC. The RHM250P variant is also...Read More...
The new EDT150 range of external 150W AC-DC power adapters are compliant with the latest energy efficiency Level VI standard...Read More...